Setting Warmer

Drawer Controls

FEATURE

OVERVIEW

ArrangingWarmer Drawer Racks

Operating & Setting Warmer Drawer Controls

Arranging Warmer (Warm & Ready TM) Drawer Rack Positions

The rack can be used in 2 ways:

In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish undemeath).

In the downward position to allow you to place light weight food items and empty dishware (for example, rolls or pastries and dinner plates) on the rack.

Set the Warmer Drawer Rack in either position as shown below (Fig. 1).

WARMER D_WER

 

 

 

 

@

 

 

 

J

OFF

 

 

 

J

 

 

 

 

J

M[

 

 

 

 

 

_Warrner Drawer

 

J

 

 

_

Rackindownward

 

F.J

Rackin upward

 

WarmerDrawer

LD

 

position

 

position

 

1

 

 

Figure

 

 

Operating the Warmer Drawer

The purpose of the Warmer Drawer is to keep hot cooked foods at serving temperature. Always start with hot food. It is not recommended to heat cold food in the Warmer Drawer. All food placed in the Warmer Drawer should be covered with a lid or aluminum foil to maintain quality. Do not use plastic

wrap to cover food. Plastic may melt onto the drawer and be very difficult

to clean. Use only utensils and cookware recommended for oven use in the Warmer Drawer.

Always use potholders or oven mitts when removing food from the Warmer Drawer as cookware and plates will be hot and you can be burned.

To Set the Warmer Drawer Control:

The control is used to select the temperature of the Warmer Drawer. It is located on the control panel. To set the control, push in and turn the knob to the desired setting. The temperatures are approximate, and are designated by HI (high), MED (medium) and LO (low).

1.Turn the knob to select the desired temperature setting.

2.For best results, preheat the drawer before adding food. An empty drawer will preheat in approximately 15 minutes.

3.When done, turn the control to OFF.

Temperature Selection

Recommended Warmer Drawer settings table is shown in Figure 3. If a particular food is not listed, start with the MED setting. If more crispness is desired, remove the lid or aluminum foil from the food. Most foods can be kept at serving temperatures on the MED setting. When a combination of foods are to be kept warm (for instance, a meat with 2 vegetables and rolls), use the HI setting. To avoid heat loss, do not open the Warmer Drawer while in use.

Warmer Drawer Indicator Light

The warmer drawer indicator light is located above the Warmer Drawer control knob (See Fig. 2). It turns on when the control is set, and stays on until the control is turned off. The Warmer Drawer is inoperable during the self-clean

cycle.

_gg

Figure 2

Warmer Drawer Recommended Food

Settings Table

Food Item

Setting

Bacon

HI

Hamburger Patties

HI

Poultry

HI

Pork Chops

HI

Fried Foods

HI

Pizza

HI

Gravies

MED

Casseroles

MED

Eggs

MED

Roasts (Beef, Pork, Lamb)

MED

Vegetables

MED

Biscuits

MED

Rolls, hard

MED

Pastries

MED

Rolls (soft)

LO

Empty Dinner Plates

LO

Figure 3

 

14

Page 14
Image 14
Kenmore 790.99012 Drawer Controls, Arranging Warmer Warm & Ready TM Drawer Rack Positions, Operating the Warmer Drawer