General Care & Cleaning
FEATURE OVERVIEW
•Removing & Replacing Warmer Drawer
Removing and Replacing Warmer (Warm & Ready TM) Drawer
[] | Pull up with finger | To Remove Warmer Drawer: |
|
|
Left Glide
1. _ | Turn power off before removing the warmer drawer. |
2.Open the drawer to the fully opened position.
3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1).
5.Pull the drawer away from the range.
Figure 1
Figure 2
To Replace Warmer (Warm & Ready TM) Drawer:
1.Pull the bearing glides to the front of the chassis glide (See Figure 2).
2.Align the glide on each side of the drawer with the glide slots on the range.
3.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while inthe
| in serious injury or death. Disconnect appliance from electric | |
'_ | "! | Shock Hazard can occur and result |
| power before cleaning and servicing the warmer drawer. | |
Oven Lights
FEATURE OVERVIEW
•Operating Oven Lights
•Replacing Oven Light
Be sure the range is unplugged and all parts are COOL before replacing oven light(s). Wear a
To Operate the Oven Lights
Both of the interior oven lights automatically turn on when the oven
door is opened. Press _ | to turn the lights ON and OFF when the |
oven door is closed. Each oven light is located at the rear wall of the oven interior and is covered with a glass shield held by a wire holder (See Figure 3). The Glass Shields must be in place whenever the oven is in use.
Wire
Holder
Figure 3
To Replace the Oven Light:
1.Turn electrical power off at the main source and unplug the range.
2.Press Wire Holder to one side to release the glass shield.
3.Replace the old bulb with a new 40 watt appliance bulb.
4.Replace Glass Shield over bulb and snap Wire Holder into place.
5.Turn power back on again at the main source (or plug in the range).
6.The clock will then need to be reset. To reset, see Setting the Clock in this Use & Care Guide.
34
