II
STEAM FUNCTIONS
To Fill the Steam Feeder
OPull out the drawer.
O Slide the lever forward to the OPEN position and lift out the steam feeder.
OOpen the lid, then fill the steam feeder up to the filter screen with tap water.
Water
SteamONLY
Feeder
O Place the steam feeder into position, then slide the lever to the rear or push the steam feeder to the rear so it is fully seated.
IMPORTANT NOTES ABOUT STEAM CYCLES
Before using a Steam Cycle, the steam feeder must be filled with water up to the filter
screen. If not, the ADD WATER light will blink. Make sure that the steam feeder is filled with water and fully seated. Turn the dryer off then restart the Steam Cycle. When steam is used
for the first time, it is possible that the steam feeder may not have enough water and the
ADD WATER light will come one. Refill the feeder and restart the cycle.
•Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
•Before moving the dryer, make sure the steam feeder is empty.
•Do not use distilled water; the water level sensor in the steam generator will not work.
•Be careful to put the Steam Feeder otherwise water will be overflow.
•Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
, WARNING:
•Do not fill the steam feeder with liquids such as gasoline,
•Do not fill the steam feeder with hot water (over 86°F/30°C).
•Do not drink water from the steam feeder.
•During steam operation, the clothes will be tumbled only for a few seconds once a minute.
27
II
