II
SIDE VENTING KIT INSTALLATION
List of Parts
The following parts are included with the pedestal.
•Duct Outlet (A) (blower - elbow)
•Duct Elbow
•Duct Outlet (B) (elbow - outlet)
•Cover Plate
•Installation Instruction
•Screw
Tools Needed
The following tools are needed for installation.
•1 #2 Phillips screwdriver
•1 adjusting wrench for leveling feet (included)
Option 1 : side venting (Gasdryerscanonlybeventedtotheleftside.)
f | Retaining |
LLLLLLL_
Rear
Exhaust Duct
ORemove the rear exhaust duct retaining screw. Pull out the exhaust duct.
Bracket
Knockout
,WARNING:
•Use a heavy metal vent.
•Do not use plastic or thin foil duct.
•Clean old ducts before installing this dryer.
•Wear gloves during installation.
•Failure to follow these instructions can result in death or fire.
Your new dryer is shipped to vent to the rear. It can also be configured to vent to the bottom or side
Option 2 : Bottom venting
Screw
LLLLLLL_
Rear
Exhaust Duct
O Remove the rear exhaust duct retaining screw. Pull out the exhaust duct.
\ | J |
Bracket
Knockout
O Press the tabs on the knockout and carefully | 0 Press | the | adapter | duct onto the blower housing |
remove the knockout for the desired vent opening | and | secure | to the | base of the dryer as shown. |
|
|
|
| |
Press the adapter duct onto the blower housing |
|
|
|
|
and secure to the base of the dryer as shown. |
|
|
|
|
........................................................................................................................J |
|
| ,J | |
f
Cover
Plate
Elbow
1112,,
(3.8 cm)
O Assemble the 4 inches (10 cm) elbow to the remaining 4 inches (10 cm) duct section, and secure all joints with duct tape. Be sure that the male end of the elbow faces AWAY from the dryer. Insert the elbow/duct assembly through the side opening and press it onto the adapter duct. Secure in place with duct tape. Be sure that the male end of the duct protrudes 11/2inches (3.8 cm) to connect the remaining ductwork. Attach cover plate
to the back of the dryer with included screw, | j_ |
34
Cover
Plate
Elbow
OInsert the 4 inches (10 cm) elbow through the rear opening and press it onto the adapter duct. Be sure that the male end of the elbow faces down through hole in the bottom of the dryer. Secure in place with duct tape. Attach the cover plate to the back of the dryer with included screw.
II
