Kenmore 911.46569 Pull the racks out to the stop lock position, Close the door, To Remove

CARE AND CLEANING

Removable Parts

CLEANING MATERIALS

- Dishwashing detergent ° Warm water

,,Scouring pad or soap-filled steel wool pad

Bump in

Rack Guide

Raised Back of

TO REMOVE

Pull the racks out to the stop lock position.

Pull up the front of the rack and

slide underthe bump of the rack guide.

TO CLEAN

Clean with warm water and detergent.

For hard to remove stains, gently

scrub with a scouring pad or a

soap-filled steel wool pad. Rinse welt.

TO REPLACE

1.Place the raised back of the rack onto the rack guides.

2.Lift the front of the rack until the raised back slides under the bump of the rack guides.

3.Slide the rack all the way back.

Broil Stop Position

TO REMOVE

1, Open the door to the broil stop position.

2.Grasp the door at each side and lift

up and off:the hinges. DO NOT

LIFT DOOR BY THE HANDLE.

				ITION:		When		the
	door			is removed			and
			hinge		arms		are	at
the	broil	stop		position,			as	a
precaution,				cover		the	hinge
arms	with		toweling			or	an
empty	paper			towel		roll.	Do
not	bump		or	try	to	move		the
hinge	arms		while		working			in
the	ovenarea.			They		could
snap	back		causing			injury		to
the	hands		or	damageto			the
porcelain			finish		of	the	front
_fra .m...e,				Ig				[11111 [

TO REPLACE

lm Make sure the hinge arms are in the broil stop position.

2.Lift the door by the sides.

3.Line Up the slots at the

bottom edge of the door with the hinge arm s .

4.Slide the door down onto the hinge arms as far as it will go.

5.Close the door.

23