AUTOMATIC OVEN COOKING
To cook food automatically in the oven, it is necessary to:
1.Set the length of the cooking time
2.Set the end of the cooking time
3.Set the temperature and the oven cooking program.
These operations are done in the follow- ing way:
1.Set the length of the cooking time
required by pushing the 
button and
the 
button to advance, or 
to go
back if you have passed the desired time (fig. 7.5). The AUTO and the 
symbol will be on.
2.Set the time you need the food to stop
cooking by pushing the 
button (the cooking time already added to the clock time will appear), and the 
button (fig. 7.6); if you pass the
desired time you can go back by pushing the 
button.
After this setting, the 
symbol will go off. If after this setting, the AUTO flashes on the panel and a buzzer goes off, it means there was an error in the programming, that is the the cooking cycle has been superimposed on the clock. In this case, change the end of cooking time or the cooking time itself by following the instructions above.
3.Set the temperature and the cooking program (see the relevant sections).
Once the oven is programmed it will switch on automatically at the right time to stop the cooking at the desired end time.
During cooking, the 
symbol remains on.
By pushing the 
button you can see the time that remains until the end of cooking.
The cooking program may be can- celled at any time by pushing 
.
At the end of the cooking time the oven
will turn off automatically, the 
symbol will turn off, AUTO will flash and the buz- zer will sound, which can be turned off by pushing any of the buttons.
Turn the switch and temperature knobs to "OFF" and put the programmer onto
“manual” by pressing the | button. |
Attention: A powercut will make the clock go to zero and will cancel the set programs.
After a powercut, three zeros will flash on the panel.
A |
U |
T |
O |
Fig. 7.5 |
20 |
A |
U |
T |
O |
Fig. 7.6 |
