Troubleshooting Guide

The messages shown below display your systems condition.

TOC Error/TOC ERROR:

•No disc has been loaded in the disc magazine.

•The CD is quite dirty. The CD is upside- down. The CD is scratched a lot.

Error 05/ERROR 05:

The disc is unreadable.

Mecha Error/Mecha ERR/Error 77/ERROR 99/ERROR 77:

The unit is malfunctioning for some reason.

Press the reset button on the unit. If the “Mecha Error”/ “Mecha ERR”/ “Error 77”/ “ERROR 99”/ “ERROR 77” code does not disappear, consult your nearest service center.

IN (Blink):

The CD player section is not operating

 

properly.

 

Reinsert the CD. If the CD cannot be

ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center.

Protect/PROTECT (Blink):

The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated.

Wire or insulate the speaker cable properly and press the reset button. If the “Protect” code does not disappear, consult your nearest service center.

Unsupported File/NA FILE:

An Audio file is played with a format that this unit can’t support.

Copy Protection/COPY PRO:

A copy-protected file is played.

Read Error/READ ERROR:

The file system of the connected USB device is broken.

Copy the files and folders for the USB device again. If the error message is still displayed, initialize the USB device or use other USB devices.

No Device/NO DEVICE:

The USB device is selected as a source although no USB device is connected.

Change the source to any source other than USB. Connect an USB device, and change the source to USB again.

N/A Device/NA DEVICE:

•An unsupported USB device is connected.

•Connection to the iPod has failed.

Remove the USB device and then reconnect it.

Check that the connected iPod is an iPod that is supported. See <About Audio file> (page 72) for information on supported iPods.

Reset iPod/ iPhone.

No Music Data/Error 15/No Music/NO MUSIC/EROOR 15:

•The connected USB device contains no playable Audio file.

•Media was played that does not have data recorded that the unit can play.

USB Error/USB ERROR:

Some trouble may have occurred to the connected USB device.

Remove the USB device, then cycle the power switch to ON. If the same display is repeated, use another USB device.

iPod Error/iPod ERROR:

Connection to the iPod has failed.

Remove the USB device and then reconnect it.

Reset iPod/ iPhone.

No Number:

• The calling party does not notify a caller ID.

 

• There is no phone number data.

No Data:

• There is no outgoing call list.

 

• There is no incoming call list.

 

• There is no missed call list.

 

• There is no phone book list.

No Entry:

The cell-phone has not been registered

 

(pairing).

HF Disconnect/HF D-CON:

The unit cannot communicate with the cell- phone.

HF Error 07:

The memory cannot be accessed.

 

Turn off the power and on again. If this

 

message still appears, press the reset

 

button on the control unit.

HF Error 68:

The unit cannot communicate with the cell-

 

phone.

 

Turn off the power and on again. If this

 

message still appears, press the reset

 

button on the control unit.

Unknown:

The Bluetooth device cannot be detected.

Device Full:

5 Bluetooth device have already been

 

registered. No more Bluetooth device cannot

 

be registered.

PIN Code NG:

The PIN code is wrong.

Connect NG:

The unit cannot be connected to the device.

Pairing Failed:

Pairing error.

76DPX504U/ DPX404U/ DPX304