Kenwood DPX503 Range, Display, Display, Audio Setup, Speaker type, 1Enter Standby, Speaker Setting, 5Exit Audio Setup mode, 2Enter Audio Setup mode

Audio Setup

You can set Sound system , such as follows;

Adjustment Item	Display	Range
Front High Pass Filter*	“HPF-F”	Through/40/60/80/100/120/
		150/180/220 Hz
Rear High Pass Filter*	“HPF-R”	Through/40/60/80/100/120/
		150/180/220 Hz
Low Pass Filter*	“LPF”	50/60/80/100/120/Through
		Hz
Subwoofer Phase*	“SW PHASE”	Reverse (180°)/ Normal (0°)
Volume offset	“VOL-OFFSET”	–8 — ±0 (AUX: -8— +8)
Loudness*	“LOUD”	OFF/ON
Dual Zone System	“2 ZONE”	OFF/ON

*Function of DPX303.

⁄

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by “Zone2” of <Function Control> (page 6).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [AUD] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 22) or [5]/[∞] button on the remote control

(page 27).

-The Audio Control has no effect on sub source.

1 Select the source to adjust

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Audio Setup modePress the [AUD] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [AUD] knob.

4Adjust the Audio setup item Turn the [AUD] knob.

5Exit Audio Setup mode

Press the [AUD] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type as follows;

Speaker type		Display
OFF		“OFF”
For 5	& 4 in. speaker	“5/4inch”
For 6	& 6x9 in. speaker	“6x9/6inch”
For the OEM speaker		“O.E.M.”

1Enter Standby

Select the “STANDBY” display.

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Speaker Setting mode Press the [AUD] knob.

“SP SEL” is displayed.

3Select the Speaker type Turn the [AUD] knob.

4Exit Speaker Setting mode Press the [AUD] knob.

English 23