Satellite Radio tuner control (Optional)

Basic Operation

Selecting Satellite Radio source

Press the [SRC] button.

Select the “SAT”/ “SIRIUS”/ “XM” display.

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

⁄

•You need to register to the service provider to receive the service by Satellite Radio. Consult the service provider if “CALL … TO SUBSCRIBE” appears.

•The radio may take a little time to start receiving after you select the Satellite Radio source.

•If the signal reception fails, “Acquiring Signal”/ “No Signal” appears.

Switching Seek Mode

Press the [AUTO] button.

Display

 

Operation

“Channel”

 

Normal manual seeking control.

“Preset”

 

Search in order of the channels in the Preset memory.

Category and Channel Search

Selecting the channel and category you want to receive.

1Enter Category and Channel Search mode Press the Control knob.2Select the Category

Push the Control knob towards up or down.

3Select the Channel

Push the Control knob towards right or left.

Cancelling Category and Channel Search mode Press the Control knob.

⁄

•You cannot Channel search until the category information is acquired.

Function of remote control

Select the channel

Push the Control knob towards right or left.

Selecting the Preset BandPush the Control knob toward up.

Each time you push the knob, the preset band alternates between the SR1, SR2, SR3 and SR4.

Channel Scan (SIRIUS only)

Press the [AUTO] button for at least 2 seconds.

Pressing this button for 2 seconds or longer allows you to check individual channel for 10 seconds each. Pressing this button again for 2 seconds or longer allows you to exit this mode.

Direct Access Tuning

Entering the channel and tuning.

1Enter Direct Access Tuning mode

Press the [DIRECT] button on the remote control.

2Enter the channelPress the number buttons.3Do Channel Search

Press the [4] or [¢] button.

Cancelling Direct Access Tuning

Press the [DIRECT] button on the remote control.

⁄

•If you make no button operation for 10 seconds, the Direct Access Tuning mode is automatically canceled.

•If you cannot receive any signal in the input Channel due to bad conditions on radio wave or other such problems, “Acquiring Signal”/ “No Signal” appears.

English 25