Kenwood DPX503 Removing the Unit, Installing the Unit, Removing the hard rubber frame, Installing in Japanese-MadeCars and General Motors Cars

Installation

Installing the Unit

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

Installing in Japanese-Made Cars and General Motors Cars

Install onto the car bracket using the supplied screws (M5 × 6 mm, M5 × 7 mm).

The holes of the car bracket to use will differ depending on the car model.

Car Bracket

Accessory5 (M5 × 7 mm) or Accessory6(M5 × 6 mm)

Removing the hard rubber frame

1Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure.

Lock Catch

Accessory4

2When the upper level is removed, remove the lower two locations.

⁄

•The frame can be removed from the bottom side in the same manner.

Removing the Unit

1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.

2Insert the two removal tools deeply into the slots on each side, as shown.

3Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.

Accessory4

¤

•Be careful to avoid injury from the catch pins on the removal tool.

4Pull the unit all the way out with your hands, being careful not to drop it.

34 DPX503/DPX303