Settings
"SOUND" Setting
"Digital Audio PCM Down Conversion" Setting
The player can output digital signal with maximum sampling rate of 96 kHz from the digital audio output connector. When a DVD disc recorded in high sampling rate PCM is played, this setting makes it possible to select whether the signal is converted into 48 kHz signal or 44.1
At the factory, the player has been set to "On" for AV amplifiers incompatible with high sampling rate digital signal connection. If the connected AV amplifier is compatible with 96 kHz digital input, change the setting to "Off".
Setting items
"
" : Select to return to the previous screen.
"On" : Select to
¶The analog output signals are also converted accordingly.
"Off" : Select to skip down conversion. Select this setting when the connected AV amplifier is compatible with 96 kHz digital input. However, if the disc inhibits the 96 kHz digital output, the signal is
¶With DVD AUDIO discs, the signal is always output after down sampling conversion.
Operation procedure
1.Set the mode switch of the joystick remote to the Purple position.
2. While the player is in stop mode, press 
and tilt the joystick up or down to display the "SOUND" menu of "SET UP MENU".
3.Press ENTER to open the setup screen.
4.In the setup menu, select "Digital Audio PCM Down Conversion" by tilting the joystick up or down and press ENTER .
Digital Audio | 7 |
PCM Down Conversion | 7 On |
Dolby Digital | 7 Off |
DTS |
|
MPEG |
|
|
|
Speaker Setting |
|
|
|
Audio During Search |
|
Dynamic Range Control |
|
Audio Filter |
|
5.Select "On" or "Off" by tilting the joystick up or down, then press ENTER to enter the selection in memory.
Chapter 2: Various Setups
"Digital Audio Dolby Digital" Setting
When a DVD recorded in Dolby Digital is played, this setting makes it possible to select the audio signal from the digital output connector of the player.
At the factory, the player has been set to "Bitstream" to enable digital connection to an AV amplifier with builtin Dolby Digital decoder. Change the setting to "PCM" when the digitally connected amplifier does not incorporate the decoder.
Setting items
"
" : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream. Select when connecting a component containing Dolby Digital decoder.
"PCM" : The signal is converted onto 48 kHz (2CH.) PCM signal before being output. Select when connecting a component without Dolby Digital decoder.
26