Digital recording

First load a tape into the unit (see page 14).

Operation is possible with either the main unit or the remote controller.

"" ~II .-

11.1111

LILI U'LILI

rl

I ST·IDmill •

LI

I

11.11 -,

ULI :J

Connect the unit (See page 11.)

Press the [REC] button.

When starting recording from the begin- ning of the tape, the unit automatically cre- ates a 5-second blank section and then enters record-standby mode.

Press the [PLAY/REPEAT] button to start recording.

You can also start recording by pressing the [PAUSE] button.

To stop recording, refer to page 20.

Changing the [VOLUME] level during recording has no effect on the recorded sound.

If five seconds elapse after the [REC] but- ton is pressed, the rotating head moves away from the tape to protect the tape. (The REC indicator blinks.)

A ST-ID is automatically recorded at the start of each tune. (See page 23.)

When carrying out digital recording from another DAT deck using a tape recorded with ST-IDs and SKIP-IDs, the same sub- codes are recorded on the new tape.

18 DX-7

Page 18
Image 18
Kenwood DX-7 instruction manual Digital recording, Connect the unit See