In case of difficulty

53

 

 

What seems to be a malfunction is not always so. Before calling for service, check the following table according to the symptom of your trouble.

Operation to reset

The microcomputer may fall into malfunction (impossibil- ity to operate, erroneous display, etc.) when the power cord is unplugged while unit is ON or due to an external factor. In this case, execute the following procedure to reset the microcomputer and return it to normal condi- tion.

÷Please note that resetting the microcomputer clears the contents stored in and it returns to condition when it left the factory.

Unplug the power cord from the power outlet then,

while holding the Power key depressed, plug the power cord again.

Amplifier section/Speakers

Symptom

Remedy

 

 

 

 

Sound is not produced.

÷ Connect properly referring to "System connections".

6

 

 

 

÷ Adjust to an required volume.

 

 

 

 

 

÷ Switch MUTE OFF.

 

&

 

 

 

÷ Unplug the headphone plug.

 

 

 

 

 

 

 

The "standby/timer" indicator blinks in red and

÷ A speaker cord is short-circuited. Turn power off and re-connect

 

 

no sound output.

the speaker cord.

 

 

 

 

 

 

 

 

 

The "standby/timer" indicator blinks in amber.

÷ Adjust the present time again.

 

r

 

 

 

 

 

 

 

 

No sound from the headphones.

÷ Insert correctly.

 

&

 

 

 

÷ Adjust to a required volume.

 

^

 

 

 

 

 

 

 

Sound is not produced from the left or right

÷ Connect properly referring to "System connections".

6

 

 

speakers.

 

 

 

 

 

 

 

 

 

 

Theclockdisplayblinkswithoutchangingthefig-

÷ Adjust the present time again.

 

r

 

 

ures.

 

 

 

 

 

 

 

 

 

Timer operation is not possible.

÷ Adjust the present time referring to "Clock adjustment".

r

 

 

 

÷ Set the timer ON time and OFF time.

 

o

 

 

÷ Press the TIMER key to set up the execution.

up

 

 

 

 

 

 

 

Remote control unit

 

 

 

 

 

 

 

 

 

 

 

Symptom

Remedy

 

 

 

Knowledgesections

 

 

 

 

 

Remote control operation is not possible.

÷ Replace with new batteries.

 

#

 

 

 

 

 

÷ Operate the unit inside the remote controllable range.

#