22

To stop playback

STOP

RETURN

Selection of reverse mode

Main unit only

1Select "TAPE RVS. ?".

menu

set / demo

\

\

volume / multi control

 

(Press the set/demo key while the "?" mark is blinking)

2Select.

section

1 " " : (ONE-WAY)

Basic

the tape stops.

 

Only one side is played back (recorded), and then

2" " : (REVERSE)

Both sides are played back (recorded), and then the tape stops. (When the playback direction is "2", however, the tape stops after one side has been played (recorded).

3" " : (ENDLESS)

Both sides are played back endlessly. (The tape stops after recording onto both sides.When the playback direction is "2", however, the tape stops after one side has been played ).

(The initial setting is " "(REVERSE))

3Set it.

set / demo

 

Playback of tape

To wind tape at high speed

To fast wind in

To fast wind in

direction

direction \

TUNING

÷Press the 7 STOP key to stop fast winding.

÷The same operation is also available with the 4 and ¢ keys on the main unit.

Selection of TAPE equalizer (TAPE EQ.)

When playing a tape prerecorded with Noise Reduction system (such as the DOLBY NR) ON, be sure to set the "TAPE EQ." ON for playback.

Lit when "TAPE EQ." is ON

TAPE EQ.

Each press switches the modes as follows. 1 "TAPE EQ." ON

(TAPE equalizer is used)

2"TAPE EQ." OFF

(TAPE equalizer is not used)

÷Select the "TAPE EQ." ON mode according to the re- cording condition of the tape.

A tip for use of the tape counter

The tape counter is set to "0000" when a cassette tape is loaded. By writing down the counter reading in case you want to interrupt recording (playback) in the middle of the tape, the memo will be helpful as a reference for locating the same position when continuing the recording (playback) the next time. The tape counter figure decrements during recording or playback of the back side (while the 2 tape transport indicator is lit). To set the tape counter to "0000", open the cassette holder once. Then the counter will be reset.