Accessories/ Installation Procedure
1
3 m (9.5 ft) .......... | 1 |
2
..........2
3
..........1
Installation Procedure
1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.
2.Set the display character conversion function switch.
3.Make the proper input and output wire connections for each unit.
4.Install the unit in your car.
5.Reconnect the - battery.
6.Press the reset button on the control unit.
•Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
To assure good reception, note the following:
•Communicate with the
m)is not always assured.
•Keep this unit away from other electric components (AV components) as far as possible. If they are near, call connection can fail, TV or radio noise can be generated, or poor reception can occur.
•A broadcast station or
If the control unit cannot display accent characters such as "ü" and "ä", set the display character conversion function switch to "2" to convert them to "U" and "A".
When one of the following control units is connected, set the switch to "2". (As of September 2006)
1 | 2 |
A : À, à, Á, á, Ã, ã, Ä, ä, Â, â, Å, å
C : | Ç, ç |
D : | Ð, ð |
E : | È, è, É, é, Ê, ê, Ë, ë |
I : | Ì, ì, Í, í, Î, î, Ï, ï |
N : | Ñ, ñ |
O : | Ò, ò, Ó, ó, Ô, ô, Õ, õ, Ö, ö, Ø, ø |
S : | ß |
U : | Ù, ù, Ú, ú, Û, û, Ü, ü |
X : | × |
Y : | Ý, ý, ÿ |
18 English