General Features (For Audio receiver)

Answering a Phone Call

When "CALL" or "Call" is displayed, "(Calling party name)" or "(Phone number)" is also displayed.

Press the [AUDIO] button or one of [1] – [6] buttons.Rejecting an Incoming CallPress the [ATT] button for at least 1 second.

•You can set up the unit so that the incoming call is received after lapse of a predetermined time. For more details, see <Setting the Time Interval for Automatic Answer> (page 11).

•Inserting a disc such as a CD will disconnect your call.

•Setting the cell-phone in the private mode can disable the hands-free function.

•When a call without caller ID arrives, "No Name No Number", "No Number", or "NO-NMBER" is displayed.

•The name of the calling party is displayed if it has already been registered in the Phone Book.

Switching to the Private Mode

You can switch between the private mode (talking directly on the cell-phone) and the hands-free mode.

Press the Control knob ([38]).

Talk modes are switched as follows:

DisplayTalk mode

"Private"/ "PRIVATE"/ "PV TALK"

Private talk

"Handsfree"/ – / "HF TALK"

Hands-free talk

•Depending on the type of your cell-phone, switching to the private talk mode may select the source that was used before commencing the hands-free connection. If this happens, the source cannot be switched back to the hands-free talk mode by operating this unit. Operate your cell-phone to return to the hands-free talk mode.

Clearing the Disconnection Message

You can clear the message displayed after disconnection of the cell-phone.

Press the [ATT] button for at least 1 second.

"Disconnect" or "DISCONCT" disappears.

•It may take some time before the disconnected cell- phone is reconnected.

Adjusting the Voice Volume during a Call

You can adjust the voice volume during a call.

Turn the [VOL] knob.

•The volume adjusted during the current call will be effective for the next and subsequent calls.

•Increasing the volume excessively is more likely to produce echo. If echo is produced, turn down the volume as low as possible. Echo increases in proportion to the volume.

Disconnecting a CallPress the [SRC] button.

•You can also press the [ATT] button for at least 1 second to end a call.

Switching between Display Modes

You can switch between the Phone Book and the Call List.

Press the [DISP]/ [AUTO]/ [TI] button.

If the [DISP] button is not provided, press the [AUTO] or [TI] button.

For the Audio receiver with Multi-function Key System:

Press the [AUTO]/ [TI] button.

Pressing this button toggles between the name list and the phone number list.

Scrolling the Display

You can scroll through the list of phone numbers or names. For the operation method, refer to <Text/ Title Scroll> in the Instruction Manual that comes with the control unit.

•With the control unit on which only the name of the calling party is displayed when receiving a call or quick dialing, you can switch to the phone number display mode by performing the above operation.

•Depending on the type of your control unit, the following restrictions are placed.

-Up to 19 characters can be displayed.

-The # letter cannot be displayed, or "" (all segments are lit) is displayed for #.

-You cannot switch between display modes.

6 English