Kenwood KCA-BT100 Icon, Icon, Icon, Display, Display, Display, Display, Setting, Display, Setting, Display, Setting, Information, Information, Information, 3Exit Menu mode

If your control unit supports a graphic display function:

1Select the status display item

Push the Control knob towards [FM] or [AM]. Select the "Phone Status" display.2Display the statuses

Push the Control knob towards [4] or [¢]. All statuses are indicated with icons.

3Exit Menu mode

Press the [MENU] button.

Bluetooth connection status

	Display	Icon	Information
	"BT-CON Y"		Connected
	"BT-CON N"		Disconnected
Battery level of cell-phone
	Display	Icon	Information
	"BAT FULL"		Full
	"BAT MID"		…
			…
	"BAT LOW"		Nearly dead
	"BAT - - -"		Cannot get information.
Signal strength of cell-phone
	Display	Icon	Information
	"SGNL MAX"		Maximum
	"SGNL MID"		…
			…
	"SGNL LOW"		Minimum
	"NO SGNAL"		Outside the service range
	"SGNL - - -"		Cannot get information.

•Since the number of steps of the control unit is different from that of the cell-phone, the statuses displayed on the control unit may discord from those displayed on the cell-phone.

In Standby mode

Setting the Time Interval forAutomatic Answer

This function automatically answers (responds to) a call after lapse of the preset time interval for automatic answer.

Display	Setting
"Auto Answer: OFF"/	Does not answer the phone call automatically.
"ANS OFF"
"Auto Answer: 0s"/	Automatically answers the phone call at once.
"ANS 0"
…
"Auto Answer: 8s"/	Automatically answers the phone call after lapse
"ANS 8"	of 8 seconds (original setting).
…
"Auto Answer: 99s"/	Automatically answers the phone call after lapse
"ANS 99"	of 99 seconds.

•If the time set in the cell-phone is shorter than that set in the unit, the former will be used.

In Standby mode

Setting up the Voice Output Speakers

You can specify the voice output speakers.

Display	Setting
"SP Select: Front"/	Outputs voice from the front-left and front-right
"SPK FRT"	speakers.
"SP Select: F-R"/	Outputs voice from the front-right speaker.
"SPK F-R"
"SP Select: F-L"/	Outputs voice from the front-left speaker.
"SPK F-L"

•Select the speaker which is further from the microphone in order to prevent howling or echos.

In Standby mode

Setting the Beep of the Incoming Call

You can output a beep from the speaker when a call comes in.

Display	Setting
"Call Beep: ON"/ "C-BP ON"	Beep is heard.
"Call Beep: OFF"/ "C-BP OFF"	Beep is canceled.

English 11