Muting upon the reception of a phone call
To use this feature, connect the MUTE lead to your telephone using a commercial telephone accessory. (See “Installation Manual” on a separate volume.)
When a call comes in, “CALL” appears.
■The audio system pauses.
■To continue listen to the audio system during a call, press 
SRC. “CALL” disappear and the audio system resumes.
When a call ends, “CALL” disappear.
■The audio system resumes.
Getting Started
Canceling the display demonstration
The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \ [VOLUME
KNOB]
1Press the volume knob.
[YES] is selected as the initial setup.
2Press the volume knob again to confirm. [DEMO OFF] appears.
■If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] in step 2, [DEMO MODE] appears and the display demonstration starts.
Setting the demonstration mode
1Press the volume knob to enter [FUNCTION].
2Turn the volume knob to select [DEMO MODE], then press to enter.
3Turn the volume knob to select [ON] or
[OFF].
If [ON] is selected, display demonstration starts if no operation is done for about 20 seconds.
4 Hold
Adjusting the clock
1Press the volume knob to enter [FUNCTION] mode.
2Turn the volume knob to select [SETTINGS], then press to enter.
3Turn the volume knob to select [CLOCK], then press to enter.
4Turn the volume knob to select [CLOCK ADJUST], then press to enter.
Clock hour flashes on the display.
5Turn the volume knob to adjust the hour, then press to enter minute adjustment. Clock minutes flashes on the display.
6Turn the volume knob to adjust the minute, then press to confirm.
Press 4 / ¢ to move between the hour and minute adjustment.
7 Hold | to finish the procedure. |
8 English