⁄

•You cannot Channel search until the category information is acquired.

Preset Memory

Putting the channel in the memory.

1Select the channel to put in the memory Push the [AUD] knob towards right or left.

2Enter Preset Memory mode Press the [SEARCH] button.

3Select the number to put in the memory Turn the [AUD] knob or push it towards up or down.

4Determine the number to put in the memory Press the [AUD] knob for at least 1 second.

Cancelling the Preset Memory mode

Press the [SEARCH] button.

⁄

•Only the channel number is stored. Category information is not stored.

Preset Tuning

Recalling the channels in the memory.

1Enter Preset Tuning Select mode Press the [SEARCH] button.

2Select a desired station in the memory Turn the [AUD] knob or push it towards up or down.

3Recall the station Press the [AUD] knob.

Cancelling Preset Tuning

Press the [SEARCH] button.

Channel Scan

Every receivable Channel is checked for 10 seconds.

1Start Channel Scan Select “CH-SCAN”.

For how to select Function Control items, refer to <Function Control> (page 6).

2Release it when the channel you want to listen to is received

Press the [AUD] knob.

Function of remote control

Direct Access Tuning

Entering the channel and tuning.

1Enter Direct Access Tuning mode

Press the [DIRECT] button on the remote control.

2Enter the channelPress the number buttons.3Do Channel Search

Press the [4] or [¢] button.

Cancelling Direct Access Tuning

Press the [DIRECT] button on the remote control.

⁄

•If you make no button operation for 10 seconds, the Direct Access Tuning mode is automatically canceled.

•If you cannot receive any signal in the input Channel due to bad conditions on radio wave or other such problems, “ACQUIRING SIGNAL”/ “NO SIGNAL” appears.

English 33