Audio Adjustments

X’Over Setting

You can set a X’Over value for the speakers;

DTA (Digital Time Alignment) Setting

Adjusting fine tuning of the speaker position compensation value specified at <Cabin selection>

Setting item

Front High Pass Filter “FRONT” >“FC” Rear High Pass Filter “REAR” >“FC”

Front High Pass Slope “FRONT” >“SLOPE” Rear High Pass Slope “REAR” >“SLOPE”

Subwoofer Low Pass Filter “SUB-W” >“FC”

Subwoofer Low Pass Slope “SUB-W” >“SLOPE”

Subwoofer Phase “SUB-W” >“PHASE”

Range

“THRU” (Through)/ 30/ 40 / 50/ 60/ 70/ 80/ 90/ 100/ 120/ 150/ 180/ 220/ 250 Hz

-6/ -12/ -18/ -24 dB/Oct.

30/ 40/ 50/ 60/ 70/ 80/ 90/ 100/ 120/ 150/ 180/ 220/ 250 Hz/ “THRU” (Through)

-6/ -12/ -18/ -24 dB/Oct.

REVERSE (180°)/ NORMAL (0°)

(page 27).

1Enter DTA setting modePress [ ] 1 sec., and select “DSP” > “SETUP” > “DTA”.

Press the [AUD] knob.

•For how to select Function Control items, refer to <Function Control> (page 10).

2

Select the speaker you want to set

 

Turn the [AUD] knob and push the center.

 

“FRONT” (Front speaker)/ “REAR” (Rear speaker)/

 

“SUB-W” (Subwoofer )

3

Set the compensation value of the speaker

 

position

 

Turn the [AUD] knob and push the center when

1Enter X’Over setting modePress [ ] 1 sec., and select “DSP” > “SETUP” > “X’OVER”.

Press the [AUD] knob.

•For how to select Function Control items, refer to <Function Control> (page 10).

2Select the speaker you want to set

Turn the [AUD] knob and push the center. “FRONT”/ “REAR”/ “SUB-W”

3Select the item you want to set

Turn the [AUD] knob and push the center.

4Set the X’Over value

Turn the [AUD] knob and push the center when the desired value is displayed.

5Exit X’Over setting mode

Press the [ ] button twice.

the desired value is displayed.

Adjust between 0 and 440 cm.

✍ Refer to <Appendix> (page 31) on how to set

the compensation value.

4 Exit DTA setting mode

Press the [ ] button.

28 KDV-U4349/ KDV-U4349M/ KDV-U4449