What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.

General

 ?  The Touch Sensor Tone does not sound.

The preout jack is being used.

The Touch Sensor Tone cannot be output from the preout jack.

 ?  The illumination flashes when the knob or button is operated.

This is the key illumination effect.

You set this effect in “ILLUMI Effect” of <Display Setting> (page 38).

 ?  The key illumination effect brought about in conjunction with the sound volume is small.

The key illumination effect may be insufficient depending on the sound volume and sound quality.

 ?  No image is output from the AV Output terminal of iPod.

“AV Out Set” is not set properly.

The “AV Out Set” of <Initial Settings> (page 43) is set ON.

The Internal Memory source or Pandora source is selected.

Since the Internal Memory source or Pandora source cannot be used together with the iPod source, the output from the AV Output terminal stops.

Tuner source

 ?  Radio reception is poor.

The car antenna is not extended. Pull the antenna out all the way.

Audio file source

 ?  The sound skips when an Audio file is being played.

The recording condition is bad.

Record the media again or use another media.

Hands-free

 ?  The hands-free talk volume is low.

The hands-free talk volume is set at a low level.

The hands-free talk volume can be adjusted independently. Adjust it during hands-free talk. “Mic Gain”, “Noise Reduction” and “Echo Cancel Level” of <Bluetooth Setting> (page 54).

 ?  No sound is heard from the rear speakers.

You are talking in the hand-free talk mode.

No sound is heard from the rear speakers in the hands-free talk mode.

 ?  No beep is heard at reception of an incoming call.

No beep is heard depending on the type of your cell-phone.

The “Call Beep” of <Bluetooth Setting> (page 54) is set ON.

 ?  Voice is not recognized.

The vehicle window is open.

If the surrounding noise is large, voice cannot be recognized properly. Close the vehicle windows to reduce noise.

Small voice.

If voice is too small, it cannot be recognized properly. Speak into the microphone a little more loudly and naturally.

The person uttering the voice tag is not the one who registered the it.

Only the voice of the person who registered the voice tag can be recognized.

Bluetooth audio source

 ?  The Bluetooth audio player cannot be registered (pairing).

The PIN code is fixed.

When a PIN code is specified in the Instruction Manual for Bluetooth Audio Player, register it with reference to <Registering PIN Code> (page 57) to register the Bluetooth audio player. If no PIN code is specified in the Instruction Manual, try “0000”.

 ?  The sound from the Bluetooth audio player is discontinuous.

The distance between this unit and audio player is too far.

Move the audio player nearer to this unit.

Another Bluetooth device is affecting the Bluetooth communication.

Turn off another Bluetooth device.

Move another Bluetooth device away from this unit.

Another Bluetooth device or profile is used for communication.

The downloading of the Phone book or the SMS disconnects the sound.

English 83