Selcall (Selective Calling)
A Selcall is a voice call to a particular station or to a group of stations.
■Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status to enter Selcall mode.
3Press the GRP and keys or rotate the CH control to select the ID of the station you want to call.
•Alternatively, you can enter a station ID using a DTMF keypad.
4Press the microphone PTT switch and begin your conversation.
•Alternatively, you can press the PF 4 key to page the selected station, rather than making a voice call.
■Receiving
An alert tone will sound, the transceiver will automatically enter Selcall mode, and the calling station’s ID will appear when a Selcall is received.
To respond to the call, press the microphone PTT switch and speak into the microphone.
■Identification Codes
An ID code is a combination of a
•Enter a Fleet number (100 ~ 349) to make a group call.
•Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.
•Enter a Fleet number make a call to all units in the selected fleet (Fleet call).
•Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).
•Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).
Note: The ID range may be limited by programming.
Status Message
You can send and receive
A maximum of 15 received messages can be stored in the Stack memory of your transceiver. These saved messages can be reviewed after reception. Depending on your dealer settings, when the Stack memory is full, either the oldest message will be erased when a new message is received or the new message will not be stored in the Stack memory.
•The
20