Kenwood TS-2000, TS-2000X, TS-B2000 manual 144

21 APPENDIX

SB	Sets or reads the SUB, TF-W status.										Parameters:
											P1
											0: SUB (TF-W) OFF
	1	2	3	4	5	6	7	8	9	10
											1: SUB (TF-W) ON
Set	S	B	P1	;
	1	2	3	4	5	6	7	8	9	10
Read	S	B	;
	1	2	3	4	5	6	7	8	9	10
Answer
	S	B	P1	;
SC	Sets or reads the SCAN function status.										Parameters:
											P1
											0: Scan OFF
	1	2	3	4	5	6	7	8	9	10
											1: Scan ON
Set
	S	C
			P1	;							2: MHz Scan ON
											3: Visual Scan ON
	1	2	3	4	5	6	7	8	9	10
											4: Tone Scan ON
Read
	S	C	;								5: CTCSS Scan ON
											6: DCS Scan ON
	1	2	3	4	5	6	7	8	9	10
Answer	S	C	P1	;
SD	Sets or reads the CW break-in time delay.										Parameters:
											P1
											0000 ~ 1000 ms (in steps of 50 ms)
	1	2	3	4	5	6	7	8	9	10
											0000 is FBK (Full break-in)
Set	S	D	P1	P1	P1	P1	;
	1	2	3	4	5	6	7	8	9	10
Read
	S	D	;
	1	2	3	4	5	6	7	8	9	10
Answer
	S	D	P1	P1	P1	P1	;
SH	Sets or reads the DSP filter settings.										Parameters:
											P1
											00 ~ 11
	1	2	3	4	5	6	7	8	9	10
											SSB/ FM (Hz)
Set	S	H
			P1	P1	;						00: 1400, 01: 1600, 02: 1800, 03: 2000, 04: 2200, 05: 2400,
											06: 2600, 07: 2800, 08: 3000, 09: 3400, 10: 4000, 11: 5000
	1	2	3	4	5	6	7	8	9	10
											AM (Hz)
Read	S	H	;								00: 2500, 01: 3000, 02: 4000, 03: 5000
											When the Packet Filter (Menu No. 50A) is ON,
	1	2	3	4	5	6	7	8	9	10
Answer											00: 170 Hz, 01: 1930, 02: 2160, 03: PSK
	S	H	P1	P1	;
SI	Enters the Satellite memory name.										Parameters:
											P1
											0 ~ 9 (Channel number)
	1	2	3	4	5	6	7	8	9	10
											P2
	S	I
			P1	P2	P2	P2	P2	P2	P2	P2	Satellite memory channel name
Set											(A maximum of 8 characters)
	11	12	13	14	15	16	17	18	19	20
	P2	;
	1	2	3	4	5	6	7	8	9	10
Read
	1	2	3	4	5	6	7	8	9	10
Answer

136