4CHANNEL SCANNING

1When you want to scan all channels for a signal, press the MODE key momentarily, three times.

The FRS, CH, and SCAN icons blink and the transceiver scans the channels from channel 1 to 14.

All channel codes are turned off during scan.

2When a signal is found on a channel, scan will pause at that channel for 10 seconds.

To resume scanning before the 10 second timer elapses, press the or key.

ENGLISH

3 To end scan and return to normal operation, press the PTT switch.

5 CODE SCANNING

1 When you want to scan all code settings on a single channel, press the MODE key momentarily, four times.

• The FRS, SUB, and SCAN icons blink and the transceiver scans the codes from code 01 to 38.

2 When a signal is found at a code setting, scan will pause at that code for 10 seconds.

• To resume scanning before the 10 second timer elapses, press the or key.

3 To end scan and return to normal operation, press the PTT switch.

9

UBZ-GR14 E 1-20

9

01.4.12, 9:35 AM

Page 12
Image 12
Kenwood UBZ-GR14 instruction manual Channel Scanning, Code Scanning