Kenwood VR-5080, VR-5090, VR-5700 How Do I Operate Devices

Using Receiver

How Do I Operate Devices?

Your Remote Control unit makes it easy for you to control the different devices connected to your receiver.

Once AV devices are connected and identified by Remote Control unit , it can use the same remote control functions as the remotes originally provided with the AV devices. (See “Chapter Two: Setting Up Remote Control Unit” of the Connection and Setup Guide.)

For the operations of each device, please also refer to the manuals provided with them.

Playback of the device connected to the CD2/TAPE2 MONITOR

These instructions are for operating a second CD player or tape deck from

asingle-Zone installation or from Zone A. For more information on op- erating devices in a multi-Zone setup, see “Chapter Two: Using Remote Control Unit in Multiple Zones” on page 54 of this manual.

1.Press the CD2/TAPE2 MONITOR button on the receiver’s front panel. The CD2/TAPE2 MONITOR indicator lights up.

2.Play the CD player or cassette deck in the same way as usual. As this cannot be controlled from Remote Control unit, use the CD player or cassette deck controls.

After completion of playback, press the CD2/TAPE2 MONITOR button again so that the CD2/TAPE2 MONITOR indicator goes out.

For detailed operating procedures of your AV device, refer to its instruction manual.

Do not connect the system control cable from the second CD player or second cassette deck, even if it supports system control.