Receiver/Tuner

If none of the above solutions work, reset the microprocessor:

1.Turn the receiver off.

2.Unplug the receiver.

3.Plug it back in while pressing and holding the Power switch (you may need someone else to help you do this)

•The component set as input (Tuner is selected by default)—see “How Do I Operate Devices?” on page 36 of this manual.

•The volume setting (-48dB is selected by default)—see “Adjusting the Volume” on page 10 of this manual

•The tuner’s receiving band (FM is selected by default)— see “Ra- dio Tuning” on page 44 of this manual

•The tuner’s frequency (87.5MHz is selected by default)— see “Ra- dio Tuning” on page 44 of this manual

•The tuner’s preset memory—you will need to reset your stored radio stations (see “Presetting radio stations” on page 45 of this manual)

•The surround setting—see “What are Listen Modes?” on page 18 of this manual

•The speaker settings—you will need to reset your speaker settings ( see Chapter Two of the Connections and Setup Guide)

Reset the cleared settings before operating the receiver again.

The sound is distorted, and the CLIP indicator on the receiver’s front panel flashes red continually, or stays red for more than 1 second at a time

Lower the analog input level for the source component you’re listening to. (Setting the proper input level eliminates distortion that occurs if a source component’s output level is too high. When this happens, the front panel CLIP indicator will flash red continually or remain red for periods of 1 second or longer. Occasional brief flashing of the CLIP indicator is okay). Adjust the analog input level for that component: See “Adjusting the Input level” on page 15 of this manual.

Troubleshooting

77