Sound
Sound
Idon’t hear any sound at all Check that:
•The volume is set at the proper level. See “Adjusting the Volume” on page 10 of this manual.
•Mute is OFF. If the MUTE indicator on the front of the receiver is blinking, MUTE is ON. See “Muting Sound” on page 16 of this manual.
•The proper input (e.g., CD player, Tuner, etc.) has been selected on the Remote Control unit. See “How Do I Operate Devices?” on page 36 of this manual.
•The proper zone has been selected. See “How Do I Switch Control Modes?” on page 54 of this manual.
•The CD2/TAPE2 MONITOR input has not been selected. (If it has, the CD2/TAPE2 MONITOR indicator on the receiver’s front panel will be lit). See “What’s on the Front Panel of Your Kenwood Audio - Video Receiver?” on page 2 of this manual.
•The input mode matches the input signal (e.g., analog vs. digital) that has been set. See “Switching Input Modes” on page 23 of this manual.
•The correct Input Mode (e.g., Full Auto) has been set for the digital input. See “Input Modes” on page 22.
•The correct speakers have been activated. See “Turning the Speakers On” on page 9 of this manual.
Audio is not output only when a 96k fs compatible disc is played.
•The optical cable may be bent. Use a new optical cable.
•Check that the optical cable connector is connected properly.
•Certain DVD player models inhibit digital output. Use analog cables with such a DVD player.
The 96k fs indicator does not light while a 96k fs compatible disc is being played.
•The indicator will not light unless the DVD player is properly set.
Troubleshooting
71