KitchenAid 9708307C Assembling Your Bowl Lift Mixer, To Raise Bowl, To Lower Bowl, To Remove Bowl

Assembling Your Bowl Lift Mixer

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

To Attach Bowl

1.Be sure speed control is OFF and stand mixer is unplugged.

2.Place bowl lift handle in down position.

3.Fit bowl supports over locating pins.

4.Press down on back of bowl until bowl pin snaps into spring latch.

5.Raise bowl before mixing.

6.Plug into a grounded 3 prong outlet.

Raise

To Raise Bowl

1.Rotate handle to straight-up position.

2.Bowl must always be in raised, locked position when mixing.

To Lower Bowl

1. Rotate handle back and down.

To Remove Bowl

1.Be sure speed control is OFF and stand mixer is unplugged.

2.Place bowl lift handle in down position

3.Remove flat beater, wire whip, or spiral dough hook.

4.Grasp bowl handle and lift straight up and off locating pins.

To Attach Flat Beater,

Wire Whip, or PowerKnead™ Spiral Dough Hook

1.Slide speed control to OFF and unplug.

2.Slip flat beater on beater shaft.

Pin

3.Turn beater to right, hooking beater over the pin on shaft.

4.Plug into a grounded 3 prong outlet.

To Remove Flat Beater,

Wire Whip, or PowerKnead™ Spiral Dough Hook

1.Slide speed control to OFF and unplug.

2.Press beater upward and turn to the left.

3.Pull beater from beater shaft.

Household Stand Mixer

Speed Control

RESET

OFF/0STIR

Plug into a grounded 3 prong outlet. Speed control lever should always be set on lowest speed for starting, then gradually moved to desired higher speed to avoid splashing ingredients out of bowl. See the “Speed Control Guide” section.

9