14
2. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
3. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.
Plug in Power™ Burner
NOTE: This built-in outdoor Power™ burner comes with a large
5000mAmp power transformer/plug assembly for the Power™
burner igniters. Follow the instructions for plugging in and
mounting the power transformer. Keep any electrical supply cord
away from any heated surfaces.
1. Plug the single-prong plug into the receptacle on the left
underside of the Power™ burner.
2. Locate or build a non-combustible surface inside the island
cabinet to mount the power transformer. It must be to the left
side of the Power™ burner at a minimum of 3" (7.6cm) from
the side and 4" (10.2cm) below the bottom of the Power™
burner.
3. Mount the power transformer to the mounting surface using
4# 8 screws (not supplied) that are the proper type and length
for the transformer and the mounting surface. It must be
mounted with the wire for the single-prong plug upward or
toward the Power™ burner.
NOTE: The cord must be properly mounted with a cord
retention device so that its 3-prong plug will not touch the
ground when it is unplugged.
4. Gently slide the Power™ burner completely into the outdoor
enclosure.
5. Plug 3-prong power cord plug into a grounded 3-prong GFI
outlet.
■To avoid electrical shock, do not immerse cord or plugs in
water or other liquid.
■Unplug from the outlet when not in use and before
cleaning. Allow to cool before putting on or taking off
parts.
■Do not operate any outdoor cooking gas appliance with a
damaged cord, damaged plug, or after the appliance
malfunctions or has been damaged in any manner.
Contact the manufacturer for repair.
■Do not let the cord hang over the edge of a table or touch
hot surfaces.
■Do not use an outdoor cooking appliance for purposes
other than intended.
■When connecting, first connect plug to the outdoor
cooking gas appliance then plug appliance into the outlet.
■Use only a Ground Fault Interrupter (GFI) protected circuit
with this outdoor cooking gas appliance.
■Do not remove the ground prong or use with an adapter
of 2prongs.
Assemble Cooking Area
1. Lift off cover and grate and set aside.
A.Closed valve
B.Open valve
A.Single-prong plug
A
B
A
A.Cover
B.Grate
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING

A

B