23
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.

Warming Drawer

(on some models)
Remove all items from inside the warming drawer, and allow the
warming drawer to cool completely before attempting to remove
the drawer.

To R emo ve :

1. Open drawer to its fully open position.
2. Locate the black loops on both sides of the drawer.
3. Pull both loops forward at the same time, then pull drawer out
another inch.
4. Holding the drawer by its sides, not its front, gently pull it all
the way out.
To Replace:
1. Align the drawer glides with the receiving guides.
2. Push drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the slides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.

Nothing will operate

■Is the power supply cord unplugged?
Plug into a grounded outlet.
■Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
■Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.

Surface burners will not operate

■Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
■Is the control knob set correctly?
Push in knob before turning to a setting.
■Are the burner ports clogged?
See “Sealed Surface Burners” section.

Surface burner flames are uneven, yellow and/or noisy

■Are the burner ports clogged?
See “Sealed Surface Burners” section.
■On models with caps, are the burner caps positioned
properly?
See “Sealed Surface Burners” section.
■Is propane gas being used?
The range may have been converted improperly. Contact a
trained repair specialist.

Surface burner makes popping noises

■Is the burner wet?
Let it dry.
A.Loop
A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING