COOKWARE | CHARACTERISTICS |
|
|
Copper | ■ Heats very quickly and evenly. |
|
|
Earthenware | ■ Follow manufacturer’s instructions. |
| ■ Use on low heat settings. |
|
|
Porcelain | ■ See stainless steel or cast iron. |
| |
steel or cast |
|
iron |
|
|
|
Stainless steel | ■ Heats quickly, but unevenly. |
| ■ A core or base of aluminum or copper |
| on stainless steel provides even |
| heating. |
HomeCanning
When canning for long periods, alternate the use of surface burners between batches. This allows time for the most recently used areas to cool.
■Center the canner on the grate.
■Do not place canner on 2 surface burners at the same time.
■For more information, contact your local agricultural department. Companies that manufacture home canning products can also offer assistance.
ELECTRONIC OVEN CONTROL
KGRS205 model shown
E F GHIJ
D
C
B
A
Q P | M | O | N | M | L | K |
A. Rapid preheat (on some models) |
| G. Timer 1 | M. Quickset |
| ||
B. Convect (on some models) |
| H. Oven display | N. Cancel/off |
| ||
C. Broil |
|
| I. Timer 2 | O. Oven light |
| |
D. Bake |
|
| J. Number pads |
| P. More options |
|
E. Setup on/off |
|
| K. Enter | Q. |
| |
F. Favorites on/off |
|
| L. Back |
|
|
|
ElectronicControlPads
When pressing any control pad function on the Electronic Oven Control, use the pad of your finger to press the desired function. Hold down the pad a few seconds, or until the desired function appears in the display.
OvenDisplay
When power is supplied to the range or after a power interruption, “12:00” and “POWER LOSS” will be displayed. Press CANCEL to clear “POWER LOSS.”
When the oven is in use, the display shows the time of day, temperature, and oven setting.
When the oven is not is use, the display shows the time of day.
When using the Timer, for settings of 1 to 59 minutes, the display will count down in minutes and seconds. For settings of 1 hour or more, the display will count down hours and minutes.
QuicksetPads
Quickset pads are located on each side of the display window and are used to select the desired function or option in the display window. To select the option or function, press the Quickset pad next to the word.
If you need to back out of a function or option in the display, press the BACK pad. When your programming is complete, press the ENTER pad or wait 4 seconds and the function will start automatically.
Up arrows indicate additional screens with additional options. Press the QUICKSET pads next to the arrows to scroll through the display.
IMPORTANT: Four seconds after entering the function, option, number or letter, the function will automatically be entered. If more than 30 seconds elapse between steps in programming, the function will be canceled and the display will return to the previous display.
8
