Tones

Tones are audible signals, indicating the following:

One Tone

Valid entry (short tone)

Two Tones

Between stages (short tones)

Reminder, repeat each minute for 10 minutes after the end- of-cycle tones

End of Timer countdown

Hidden feature entered or exited (very short, quick tones)

Three Tones

Invalid entry (very short, quick tones)

Retry Error

Four Tones

End of cycle (2 short tones, followed by 2 longer tones)

Interruption, tend to food (short tones)

Attention - door needs to be opened and closed

To Adjust Tone Volume:

1.On Main Menu, touch “Settings & Info.”

2.On Settings & Info screen, touch “More Choices.”

3.Touch “Volume.”

4.Using “+” and “-” controls, increase or decrease the volume setting, or turn the tones off.

5.Touch “Ok.”

Start

The START control will start any function.

If non-sensor cooking is interrupted, touching the START control pad will resume the preset cycle.

If the microwave oven has not been in use and the door has not been opened in the past 5 minutes, the cooking function will not start. Open and close the door, then touch START to start or resume the cooking cycle.

For added convenience, the “Start” touch pad is also available on some display screens, and provides the same function as the START control pad.

Off

The OFF control stops all functions except for the Timer and Learning Mode, and cancels programming in progress.

The microwave oven will also turn off when the door is opened. Close the door and touch START control or “Continue” on the touch screen to resume the cycle. A sensor cooking cycle may not be resumed if interrupted by opening the door.

Clear

During programming, the CLEAR control changes the numeric programming values, such as minutes, seconds and cook power that are active in the display to their default value. For example, while entering a cook time, touching CLEAR will change the time you have already entered to “0:00.” The CLEAR control gives an invalid signal (see “Tones” section) if touched during cooking.

Timer

The Timer can be set in minutes and seconds, up to 99 minutes, and counts down the set time.

NOTE: The Timer does not start or stop the microwave oven.

A

A. Timer indicator

While the Timer is in use, the microwave oven can still operate. During a microwave oven operation, the Timer countdown will be minimized. If the Timer ends while microwave oven is still operating, the end-of-Timer tones will sound, and the set operating mode will remain active on the screen.

To Set Timer:

1.Touch TIMER control.

2.Using the number pads, enter desired time in minutes and seconds, and then touch “Start Timer.”

The countdown will be in full screen view.

3.Touch “Ok” to minimize the timer.

To see the countdown in full screen view, touch TIMER control.

The time can be reset during the countdown by touching TIMER, entering a new time, then touching “Ok,” or the START control.

To Cancel: Touch TIMER control, then touch “Cancel Timer.”

ControlLock

The Control Lock disables all controls to avoid unintended use of the microwave oven. The only control that will function while the Control Lock is active is the OFF pad on the control panel.

Control Lock activation is possible only when the display is at the Main Menu.

To Activate Control Lock: Touch and hold OFF control for

5 seconds. Two tones will sound, and the display will show the padlock icon.

12

Page 12
Image 12
KitchenAid KHHC2090S manual Tones, Start, Off, Clear, Timer, ControlLock