INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the safety instructions provided with any tools listed here. Additional tools may be required to cut contertop and install drain lines.
Tools needed:
■Utility knife
■5/8"
■7/16" deep well socket
■small tubing cutter
■tape measure
■flat bladed screwdriver
■plumber’s putty
■10" adjustable wrench that opens to
■Teflon® tape or pipe joint compound
■1 cartridge silicone caulk and caulk gun
■sink strainer locknut wrench
Parts needed:
■Copper tubing with compression fitting for water fill line (3/8" is recommended). Length needed is determined by specific installation requirements.
■Copper tubing with compression fittings for faucet connection. Length and diameter needed are determined by specific faucet installation requirements.
■faucet
■2,
■
■90° elbow with 3/8" N.P.T. external threads on one end. (The other end must fit your water supply line.)
In addition, if direct wiring:
■1/4" hex nut driver
■2,
■
Parts supplied:
■Undercounter clamp brackets – adjustable for countertops 3/4" (1.9 cm) to
■cutting board
Location Requirements
Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty.
If dishwasher will be left unused for a period of time or in a location where it may be subject to freezing, have it winterized by authorized service personnel.
The dishwasher is shipped ready for installation of a
If the hot water accessory tank, Part No. 4396282 will be used, the tank should be installed first. It may be difficult to install the drain line to the T&P valve on the hot water accessory tank, if it is not installed first.
3
