501974402003_UK
11 Cleaning and maintenance
•Wash the infuser under running water, without using detergents. Never wash the infuser in the dishwasher;
•clean the inside of the appliance thoroughly. To remove coffee encrustations from the inside of the appliance, scrape with a plastic or wooden fork (fig. 25) then vacuum up the residues with a vacuum cleaner (fig. 26);
•replace the infuser by sliding it onto the supports and pin at the bottom, then push the PUSH symbol fully in until it clicks into place.
Support
Pin
Infuser
Push the PUSH symbol fully in until it clicks into place.
After having heard the click, check that the red buttons have snapped out.
Bottom pipe on the infuser.
The pin must be inserted into the bottom pipe on the infuser.
Check that the two red buttons have snapped out, otherwise the door cannot be closed.
The two red buttons | The two red buttons |
have snapped out | have not snapped out |
CORRECTLY |
|
CORRECT INCORRECT
NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snapped out, the service door cannot be closed.
NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it forcefully from the top and bottom simultaneously, as shown in figure 27.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from the mains then plug in again.
Wait for all the lights to go off, then open the door and replace the infuser.
•replace the drip tray, complete with the grounds container;
•close the service door.
19
