KitchenAid W10520792B manual Install Custom Overlay Panel, Door Reversal-Side Swing Only

WARNING

Excessive Weight Hazard

Option 1—Without Hinge-Side Space

Use two or more people to move and install ice maker. Failure to do so can result in back or other injury.

2.Style 1—For gravity drain system, push the ice maker into position so that the ice maker drain tube is positioned over the PVC drain reducer. See “Gravity Drain System.”

Style 2—For drain pump system connect the drain pump outlet hose to the drain. See “Drain Pump System.”

3.Recheck the ice maker to be sure that it is level. See “Leveling.”

4.If it is required by your local sanitation code, seal the cabinet to the floor with an approved caulking compound after all water and electrical connections have been made.

29¹⁄₂"

(74.9 cm)

14¹⁷⁄₃₂"

(36.9 cm)

A

B

C

Install Custom Overlay Panel

IMPORTANT: Create custom overlay panel according to the specifications in the “Custom Panel Dimensions” section.

1.Install the ice maker.

2.Level the ice maker. See “Leveling.”

3.Place the ice maker under the cabinet so that the front edge of the custom panel will align with the front edge of the surrounding cabinets.

4.Hold the custom panel up to the ice maker and check that the opening and alignment are correct. Mark location of the panel as necessary.

5.Mark location of the handle. Remove the panel from the door and drill holes for the handle.

6.Install the door handle on the panel.

7.Remove the tape from the face of the door.

8.Remove the paper backing from the adhesive pads that are located on the door front.

9.Place the panel on the door, align with markings and apply pressure in the area of the adhesive pads.

10.Make sure the ice maker door opens and closes easily.

11.Pull the ice maker forward to access the top and sides of the door.

12.Remove the gaskets from the interior door panel and set aside.

13.Using the factory drilled holes as a guide, use a scribe and mark the drilling locations on the overlay panel.

14.Drill eight ¹⁄₈" x ¹⁄₂" (3.18 mm x 12.7 mm) deep holes into the overlay panel.

NOTE: Do not drill deeper than ¹⁄₂" (12.7 mm).

15.Use eight #8 x ¹⁄₂" pan-head wood screws to attach the panel to the door.

16.Replace the gaskets on the inner door panel.

17.Move the ice maker back into place under the counter.

A. #8 x ¹⁄₂" pan-head	B. Adhesive pads
wood screw	C. Custom panel

Option 2 - With Hinge-Side Spacer

A

B

29¹⁄₂"

(74.9 cm)

C

14⁵⁄₈"
(37.1 cm)
A. #8 x ¹⁄₂" pan-head	B. Adhesive pads
wood screw	C. Custom panel

Door Reversal—Side Swing Only

Tools Needed

Gather the required tools and parts before starting installation.

■	⁵⁄₁₆" wrench	■	Flat putty knife
■	¹⁄₄" wrench	■	Phillips screwdriver

Hinge pin	⁵⁄₁₆" hex-head hinge screw
Handle screw	End cap screw

11