Kodak 9500 manual GX End of job HA Set mode HC Next image address

GX — End of job

HA — Set mode

HC — Next image address

The GX command initiates the scanner End of Job sequence. This sequence includes:

• turning off the feeder

• flushing the transport

• turning off the transport

• disabling scanning

NOTE: The image buffer is not cleared.

Data Field	Command Field
none	G	X

The HA command changes the current scanner configuration to the configuration defined by the specified application mode.

	Data Field	Command Field
	mode	H		A
Data Field	Description			Value(s)
mode	mode number		1–18

NOTE: Only one Set Mode command may be sent with each SCSI Send command.

The HC command sets the image address for the next document.

	Data Field		Command Field
STX	image address	ETX	H		C
Data
Field	Description			Value(s)
STX	start of transmission indicator			02H
Image	the image address which is to be			see
Address	assigned to the next document			NOTES
ETX	end or transmission indicator			03H

NOTES:

•The image address format must be compatible with the current application mode. It must be sent to the scanner as if it were entered on the scanner operator control panel. It should only be sent when the scanner is idle.

•STX and ETX are optional when specifying numeric-only image addresses. If the image address contains upper-case alphabetic characters, STX and ETX must be used.

6-8 A-61124 March 1999