Kodak 9500 manual Description Values

BX/Y/Z — Scan resolution

CX — Clear buffers

DC — Sequential ID initiator

The BX/Y/Z command defines scanning resolution for the current mode.

	Data Field	Command Field
	res	B	X/Y/Z
Data Field	Description		Value(s)
res	scan resolution in dots per inch		70 to 300*

*Values must be specified in increments of 10 dpi. If not, values will be rounded to the nearest 10 dpi by the scanner.

NOTE: Leading zeros are not permitted.

The CX command resets the image buffer and initializes the Sequential ID Number to 1. This command is intended for use only during integration testing and should not be used in a production scanning application.

IMPORTANT: Executing the CX command may cause images in the buffer to be lost. Similarly, if the command is executed while there are documents in the transport, the new images may also be lost.

Data Field	Command Field
none	C	X

The DC command is used to set the Sequential ID Number (document count).

	Data Field		Command Field
cnt		level	D		C
Data Field		Description		Value(s)
cnt	image number value			0–999999999
level				9

The following example shows how the DC command could be used:

The host application wants the starting image Sequential ID Number (document count) to be 101.

The Sequential ID Initiator command must enter a value one less than the desired starting value (to start with 101, the cnt value must be 100).

HEX	31	30	30	39	44	43
CHAR	1	0	0	9	D	C

A-61124 March 1999 6-5