8

Using an EYE-FI Card

This chapter pertains only if you’re using an EYE-FI Card.

An Eye-Fi Card stores pictures in the same way that an SD/SDHC Card does. It also has a built-in Wi-Fi antenna that uses your Wi-Fi network to transfer pictures from your camera to your computer or mobile device.

IMPORTANT: Choose an EYE-FI X2 Card or higher, with a firmware version of 4.5174 or higher. View and update firmware using the Eye-Fi Center Software that accompanies the card.

Storing pictures on an EYE-FI Card

To set up and use the EYE-FI Card and EYE-FI Center Software, follow the EYE-FI documentation to set up the card. For further EYE-FI support, go to support.eye.fi.

CAUTION:

If you’re using an EYE-FI Card in this camera, it’s critical that you disable (do not turn on) Endless Memory Mode in EYE-FI Center Software.

Accessory

1 Turn off the camera, then open the door.

2Insert a card until it clicks.

To remove a card, press and release it.

IMPORTANT: When you turn on the camera, it checks to see if a card is inserted. If pictures/videos are detected in internal memory, the camera prompts you to move them to the card. New pictures/videos are stored on the card.

 

Get support for EYE-FI Cards and Software support.eye.fi

41

www.kodak.com/go/support

Page 48
Image 48
Kodak C135 manual Using an EYE-FI Card, Storing pictures on an EYE-FI Card