Kodak i250, i260

D-2 A-61167 September 2002

4. Remove the scanner front panel.

IMPORTANT:The scanner will not operate if the dockable flatbed is not

securely attached.

5. Slide the flatbed close to the opening.

6. Push the flatbed against the scanner until the docking latches click

into place.

7. Attach the scanner front panel to the mounting posts on the back of the

flatbed for storage.

You will need to re-attach this panel to the scanner if you remove the

flatbed from the scanner.

8. Power up the scanner.

The flatbed is ready to use.

NOTE:Lower the input t ray when you are going to use the automatic

document feeder instead of the flatbed.

Contents

Main Page Contents Page Page Introduction Optional Accessories Scanner Features Paper Transport Features Speed/Capacity (Throughput) Image Quality Features Maintenance Preparing Documents for Scanning Recommended Documents Safety Information Warning Labels User Precautions Safety and Regulatory Agency Approvals Environmental Information EMC Statements For the United States Power System For Japan For Taiwan Installing the Scanner Site Specifications System Requirements Unpacking the Scanner Registering Your Scanner Removing the Foam Sheet Scanner Components Front 10 A-61167 September 2002 Rear Side Internal Making Connections Installing the IEEE-1394 (FireWire) Card in the Host Computer Installing the Kodak Driver Software Power Setup Page Page Input and Output Trays Attaching the Input Tray Attaching the Output Tray Tray Extenders and Side Guides Adjusting the Output Tray Closing the Input and Output Trays Installing Optional Accessories Using the Scanner Starting and Stopping Scanning Automatic Feeding Continuous Feeding Manual Feeding Damaged Documents Maintenance Cleaning the Scanner Cleaning the Separator Module Page Cleaning the Feed Module Cleaning the Drive Rollers and TransportArea Cleaning the Imaging Guides Cleaning the Paper Path Replacing Wear Parts Replacing the Separator Module Replacing the Feed Module Calibrating the Scanner Troubleshooting Indicator Lights Lamps Clearing Document Jams Adjusting the Separator Module Tens ion System Is Not Responding Color Image Quality Problem Solving Problem Possible Solution Transporting the Scanner Problem Possible Solution Appendix A Specifications Page Appendix B Supplies and Accessories Appendix C KODAK i200 Series Imprinter Contents of the Imprinter Kit Installing the Imprinter Removing the Circuit Board Cover Page Page Page Page Page Completing the Imprinter Installation Page Installing the Ink Blotter Strips Purging an Ink Cartridge Installing an Ink Cartridge Page Imprinter Maintenance Replacing the Ink Blotter Strips Replacing the Ink Cartridge Carrier Imprinting Overview Print Characters Imprinter Specifications Appendix D KODAK i200 Series Dockable Flatbed Page Using the Flatbed Book Scanning Calibrating the Flatbed Cleaning the Flatbed After a Power Failure Removing the Dockable Flatbed Page Appendix E Installing Optional Memory