Kodak i250, i260 Replacing the Ink Blotter Strips

A-61167 September 2002 C-15

Replacing the

Ink Blotter Strips Two ink blotter strips in the scanner collect ink overflow. These strips should be

replaced as necessary. To order additional ink blotter strips, refer to Appendix

B, Supplies andAccessories.

NOTE: Improperly aligned blotter strips may cause paper jams.

1. Power down the scanner.

2. Disconnect the power cord.

3. Remove any documents from the feeder area.

4. Lift up the scanner door release to unlatc h the scanner door.

5. Pull up to open the scanner door.

6. Locate the two ink blotter strips in the rear of the transport area.

7. Grasp a blotter strip and carefully pul l it off.

8. Discard the soiled strip.

9. Remove the other blotter strip and discard it.

Contents

Main Page Contents Page Page Introduction Optional Accessories Scanner Features Paper Transport Features Speed/Capacity (Throughput) Image Quality Features Maintenance Preparing Documents for Scanning Recommended Documents Safety Information Warning Labels User Precautions Safety and Regulatory Agency Approvals Environmental Information EMC Statements For the United States Power System For Japan For Taiwan Installing the Scanner Site Specifications System Requirements Unpacking the Scanner Registering Your Scanner Removing the Foam Sheet Scanner Components Front 10 A-61167 September 2002 Rear Side Internal Making Connections Installing the IEEE-1394 (FireWire) Card in the Host Computer Installing the Kodak Driver Software Power Setup Page Page Input and Output Trays Attaching the Input Tray Attaching the Output Tray Tray Extenders and Side Guides Adjusting the Output Tray Closing the Input and Output Trays Installing Optional Accessories Using the Scanner Starting and Stopping Scanning Automatic Feeding Continuous Feeding Manual Feeding Damaged Documents Maintenance Cleaning the Scanner Cleaning the Separator Module Page Cleaning the Feed Module Cleaning the Drive Rollers and TransportArea Cleaning the Imaging Guides Cleaning the Paper Path Replacing Wear Parts Replacing the Separator Module Replacing the Feed Module Calibrating the Scanner Troubleshooting Indicator Lights Lamps Clearing Document Jams Adjusting the Separator Module Tens ion System Is Not Responding Color Image Quality Problem Solving Problem Possible Solution Transporting the Scanner Problem Possible Solution Appendix A Specifications Page Appendix B Supplies and Accessories Appendix C KODAK i200 Series Imprinter Contents of the Imprinter Kit Installing the Imprinter Removing the Circuit Board Cover Page Page Page Page Page Completing the Imprinter Installation Page Installing the Ink Blotter Strips Purging an Ink Cartridge Installing an Ink Cartridge Page Imprinter Maintenance Replacing the Ink Blotter Strips Replacing the Ink Cartridge Carrier Imprinting Overview Print Characters Imprinter Specifications Appendix D KODAK i200 Series Dockable Flatbed Page Using the Flatbed Book Scanning Calibrating the Flatbed Cleaning the Flatbed After a Power Failure Removing the Dockable Flatbed Page Appendix E Installing Optional Memory