Kodak i250, i260

E-2 A-61167 September 2002

8. Lift up the scanner door release again and open the scanner door past the

circuit board cover.

9. Use a Phillips-head screwdriver to remove the two screws (one front, one

back) that hold the circuit board cover in place.

NOTE: If the optional imprinter has been installed, disconnect the imprinter

cable from the imprinter board before you remove the circuit board

cover. Refer to Appendix C, KODAK i200 Series Imprinter, for

information about the imprinter cable.

10. Lift up the circuit board cover and remove it.

Circuit board cover

Contents

Main Page Contents Page Page Introduction Optional Accessories Scanner Features Paper Transport Features Speed/Capacity (Throughput) Image Quality Features Maintenance Preparing Documents for Scanning Recommended Documents Safety Information Warning Labels User Precautions Safety and Regulatory Agency Approvals Environmental Information EMC Statements For the United States Power System For Japan For Taiwan Installing the Scanner Site Specifications System Requirements Unpacking the Scanner Registering Your Scanner Removing the Foam Sheet Scanner Components Front 10 A-61167 September 2002 Rear Side Internal Making Connections Installing the IEEE-1394 (FireWire) Card in the Host Computer Installing the Kodak Driver Software Power Setup Page Page Input and Output Trays Attaching the Input Tray Attaching the Output Tray Tray Extenders and Side Guides Adjusting the Output Tray Closing the Input and Output Trays Installing Optional Accessories Using the Scanner Starting and Stopping Scanning Automatic Feeding Continuous Feeding Manual Feeding Damaged Documents Maintenance Cleaning the Scanner Cleaning the Separator Module Page Cleaning the Feed Module Cleaning the Drive Rollers and TransportArea Cleaning the Imaging Guides Cleaning the Paper Path Replacing Wear Parts Replacing the Separator Module Replacing the Feed Module Calibrating the Scanner Troubleshooting Indicator Lights Lamps Clearing Document Jams Adjusting the Separator Module Tens ion System Is Not Responding Color Image Quality Problem Solving Problem Possible Solution Transporting the Scanner Problem Possible Solution Appendix A Specifications Page Appendix B Supplies and Accessories Appendix C KODAK i200 Series Imprinter Contents of the Imprinter Kit Installing the Imprinter Removing the Circuit Board Cover Page Page Page Page Page Completing the Imprinter Installation Page Installing the Ink Blotter Strips Purging an Ink Cartridge Installing an Ink Cartridge Page Imprinter Maintenance Replacing the Ink Blotter Strips Replacing the Ink Cartridge Carrier Imprinting Overview Print Characters Imprinter Specifications Appendix D KODAK i200 Series Dockable Flatbed Page Using the Flatbed Book Scanning Calibrating the Flatbed Cleaning the Flatbed After a Power Failure Removing the Dockable Flatbed Page Appendix E Installing Optional Memory