12 A-61167 September 2002
Power Setup Several power cords are supplied with the scanner. Use only the cord required
for your type of power. Dispose of the unneeded power cords properly.
Use only the power supply that was provided with the scanner.
CAUTION:The power supply must only be used indoors in a dry location.
IMPORTANT:Do not substitute another power su pply model or another
manufacturer’s power supply.
1. Press the side labeled “O” on the power switch to make sure that the
power is off.
NOTE:The power switc h is on the power supply.
2. Attach the power cord for your power type to the power supply.
3. Attach the power supply to the power input on the back of the scanner.
4. Plug the power cord into a power outlet.
NOTE:Make sure that the power ou tlet is located within 1.52 metres (5 feet) of
the scanner and is easily accessible.
5. Press the side labeled “I” on the power switch to power up the scanner.
After you power up the scanner, the red and green indicator lights will
illuminate. After approximately one minute, both lights go out. When
the green indicator light comes back on, the scanner is ready to begin
scanning. However, the host computer may require a few more seconds
to detect the scanner.
On/Off (I/O) switch