9-16 Process ECP-2E Specifications
Table 9-7 Mechanical Specifications for Rewash RW-1
Process Steps
KODAK
Formula Tempera ture
*
* Fahrenheit temperatures are primary. Celsius temperatures are rounded consistent with process-control requirements.
Time Replenisher
(Wash Rate)
per 100 ft.
(30.5 m) of
35 mm Film
†
† For 16 mm film, use one-half the 35 mm film replenishment and wash rates.
Recirculation (R);
Filtration (F)
Tank and
Replenisher °C °F min:sec
Prebath PB-6 21 ± 170 ± 2 2:00 600 mL R & F
@ 20 to 40 L/min
Wash — 21 to 38 70 to100 3:00 300 mL
‡
‡ Use a two-stage countercurrent wash.
None
Final Rinse FR-1 21 to 38 70 to100 :10 400 mL R & F
@ 20 to 40 L/min
PROCESSING CHEMICALS AND FORMULASPackaged Chemicals
Kodak packaged chemical kits are available for the solutions
used in Process ECP-2E. Solutions may also be prepared
according to the Formulas and Analytical Specifications,
using chemicals purchased in bulk.
Bulk Chemicals
The list of suppliers below is not intended to be all-inclusive,
nor are the suppliers listed in any order of preference. The
mention of a supplier is not intended as a recommendation
by Eastman Kodak Company. Most of the chemicals listed
are available from local chemical supply houses. For
additional suppliers, consult Chemical Week, Chemical
Buyers, or Thomas’ Register in public libraries.
Information on the known hazards and safe handling of
the following chemicals is available from the supplier of the
chemical in the form of chemical container labels and
Material Safety Data Sheets (MSDS) as required by the
OSHA Hazard Communication Standard Act and many state
laws.