3.11.3 Cylinder Lubrication
1.Remove the spark plugs.
2.Pour one tablespoon of engine oil into each spark plug hole. Install the spark plugs and ground the spark plug leads. Do not connect the leads to the plugs.
3.Toggle the generator set master switch to crank the engine two or three revolutions to lubricate the cylinders.
3.11.4 Exterior Preparation
1.Clean the exterior surface of the generator set.
2.Seal all openings in the engine with nonabsorbent adhesive tape.
3.Mask all areas to be used for electrical contact.
4.Spread a light film of oil over unpainted metallic surfaces to prevent rust and corrosion.
3.11.5 Battery
Perform battery storage last.
1.Place the generator set master switch in the OFF/RESET position.
2.Disconnect the battery, negative
3.Clean the battery. Refer to Section NO TAG for the cleaning procedure.
4.Place the battery in a warm, dry location.
5.Connect the battery to a float/equalize battery charger, or charge the battery monthly using a trickle charger. Follow the battery charger manufacturer’s recommendations.
Section 3 Scheduled Maintenance 17 |
