Kramer Electronics RC-8IR Using Your Universal Room Controller2, Your RC-8, Your RC-6IR

Introduction

4.2Your RC-8

The RC-8is similar to the RC-8IR, without items 3 and 9 in Table 1.

4.3Your RC-6IR

The RC-6IRis similar to the RC-8IR, just with 6 configurable control buttons1 (instead of 8).

4.4Your RC-6

The RC-6is similar to the RC-8just with 6 configurable control buttons1 (instead of 8).

5Using Your Universal Room Controller2

This user manual is applicable once the unit is installed and configured3. The installation process is not detailed in this user manual4, and includes:

￿￿Setting up the labels on the buttons, according to your specific requirements5

￿￿Hardware installation

￿￿Connecting the inputs and the display

￿￿Configuration via the Windows®-based configuration software and/or the IR learner

The universal room controller is very easy to use, as the example in Figure 3 and Table 3 defines6:

1 Item 4 in Table 1

2 From this section on, all the information is relevant to the RC-6, RC-8, RC-6IR and RC-8IR units, unless noted otherwise 3 By authorized Kramer technical personnel or by an external system integrator

4 Refer to the separate online guide at http://www.kramerelectronics.com

5 It is recommended to place labels on the buttons prior to installing the unit, as this involves removing the face plate

6 Your RC-8IR was installed and configured to suit your specific requirements. This example describes how to setup one of an unlimited number of available setups for the system

5