Kramer Electronics user manual Connecting the VS-88DTP

5 Connecting the VS-88DTP

i	Always switch off the power to each device before connecting it to your
	VS-88DTP. After connecting your VS-88DTP, connect its power and
	then switch on the power to each device.

To connect the VS-88DTPas illustrated in the example in Figure 3:

1.Connect up to eight DVI sources (for example, computer graphics sources)

to the IN 1 to IN 8 DVI connectors.

You do not have to connect all the sources.

2.Connect the OUT 1 to OUT 8 TP connectors to up to eight TP receivers (for

example, the PT-572HDCP+and TP-574).

You do not have to connect all the outputs.

3.If required, connect a controller to the RS-232 (see Section 5.1) and/or Ethernet port (see Section 5.3).

4.Connect the power cord (not shown in Figure 3).

5.If required, acquire the EDID (see Section 6.5).

10 VS-88DTP - Connecting the VS-88DTP