Krell Industries MD2 manual D. Dust Cover Installation

CAUTION: FAILURE TO REMOVETRANSPORT SCREWS BEFORE OPERATION COULDRESULT IN DAMAGETO THE TRANSPORT.

CAUTION: FAILURE TO REMOVETHE PROTEC- TIVE HUB BEFORETHE UNIT IS PLUGGEDINTO THE AC RECEPTACLE OR BEFORE OPERATION COULDRESULT IN,DAMAGE TO THE TRANS-

PORT.~

D. DUST COVER INSTALLATION

1. Standard Version SmokedDust Cover:

Removethe dust cover, in its protective sleeve, fromthe shipping foam. To prevent scratching leave the protective

sleeve on the dust cover until the cover mountingis complet.e. Thereare two pairs of screwsw.ith wasOer-type receptacles attached to the backpanel of the unit tor mountingthe dust cover. Center the hinge pins on the dust cover over the two pairs of screws. Carefully slide

the hinges into the slots Formedby the washers. Pushthe cover downevenlyon both sides until it is fully seated. Finally, removethe protective sleeve.

2. CustomVersion Clear Lucite Dust Cover:

Removethe dust cover from the protective foamand its protective sleeve. Thereare twopairs of screwswith

washer-typehinge receptacles on the back. of the un!t. Removethe four screwgfromthe unit ancl take off the

black hinge receptacles. Carefully place the lucite dust

cover such that the circular milled-out portion,is centered over the transport. Alignthe slots in the cover s hinge blocks with ttie holes in the backof the chassis. Thread the four screwsinto the chassis through the hinge blocks. Tightendownlightly and adjust the coverso it is ce.n- tered on the unit. Oncethe cover is aligned tighten clown the supporting screws.

NOTE:The clear lucite cover must be lowered manually, as it is very heavyand does not have a damping mechanism.