Preparation before Use
2-44
Loading Originals
Follow the steps below to load originals for copying, sending or storing.

Placing Originals on the Platen

You may place books or magazines on the platen in addition to ordinary sheet originals.
1Open the document processor.
NOTE: Before opening the document processor, be
sure that there are no originals left on the original table
or on the original eject table. Originals left on the
original table or on the original eject table may fall off
when the document processor is opened.
Keep the document processor open if the original is 25
mm or thicker.
2Place the original. Put the scanning side facedown
and align it flush against the original size indicator
plates with the back left corner as the reference
point.
3Close the document processor.
IMPORTANT: Do not push the document processor
forcefully when you close it. Excessive pressure may
crack the platen glass.
Do not close the document processor when the original
is 25 mm or thicker. The connector of the document
processor will be removed form the machine.
NOTE: Shadows may be produced around the edges
and in the middle of open-faced originals.
CAUTION: Do not leave the document processor
open as there is a danger of personal injury.