Troubleshooting
Printed Results |
| Corrective Action | ||||
|
|
|
|
|
| |
| Refresh drum. | |||||
| Perform the following procedures on the operation panel and try | |||||
| cleaning the drum surface using the printer's | |||||
| system. | |||||
| 1 | Press [MENU]. | ||||
| 2 | Press U or V repeatedly until >Others appears. | ||||
| 3 | Press Z. Press U or V repeatedly until >Service appears. | ||||
| 4 | Press Z. Press U or V repeatedly until >>Drum appears. | ||||
| 5 | Press [OK] ([ENTER]) twice. | ||||
| 6 | The message display shows Please wait. After approx. 3 | ||||
|
| minutes, the display returns to Ready. | ||||
Grey background | Clean the main charger units. | |||||
| Open the left cover. Slowly pull the green wire cleaner knob to | |||||
| each of the main charger units in and out a few times. For full | |||||
| details, see Cleaning the Main Charger Unit on page | |||||
|
|
|
|
|
| |
| Check the charger units installation. | |||||
| Open the left cover and check that the charger units are correctly | |||||
| installed and seated as far as it will go. see Cleaning the Printer on | |||||
| page | |||||
|
|
|
|
|
| |
| Conduct color calibration either by switching the printer off then on | |||||
| or using the printer operation panel. | |||||
|
|
|
|
|
| |
Dirt on the top edge or back of the | Check the paper chute and the ramp. | |||||
paper | Pull out the paper transfer unit and check for toner on the paper | |||||
| ramp. Clean the paper ramp using a soft, dry, | |||||
| details, see Cleaning the Paper Transfer Unit on page | |||||
|
| Paper Ramp |
|
| ||
|
|
|
|
|
| |
|
|
|
| |||
|
|
| ||||
|
|
|
|
|
|
|
OPERATION GUIDE |