CHAPTER 6 TROUBLESHOOTING
6-10
2Grasp the handles A of the roll unit to unlock the unit and
pull out the roll unit until it stops.
3Grasp the flange and rewind the paper roll.
4If there is any wrinkled or folded area, remove it with a
cutting knife or scissors.
5Grasp both of the paper roll insertion latches 3 and open
the paper roll insertion cover 4.
6Insert the leading edge of the paper under the paper roll
insertion guide and advance the edge past the guide
approximately 1/2" [10 mm] as shown in the illustration.
7Grasp both of the paper roll insertion latches and close the
paper roll insertion cover.
IMPORTANT
If the paper roll that has been loaded has slackened, grasp the flange
and wind the paper roll to remove the slack. If not, the paper may be
fed obliquely.
8Push the roll unit securely back into the machine.
9Close the front cover.
10 If the leading edge of the paper is not cut straight, press the
Roll Cut key.
The leading edge of the paper will be cut.
A
A
3
3
4
1/2"
[10mm]